Activedumpsnet Logo
An administrative user sends a Word document as an attachment to their coworker using the email client.
Which protocol is used to complete this transaction?
What is a key characteristic of a Type 2 hypervisor?
What benefit is offered by modular servers over rack servers?
A system administrator needs to configure their Dell EMC PowerEdge server for PXE boot in UEFI mode. What is the correct order of steps to accomplish this?
What process divides the data into blocks across multiple disk drives?
An IT architect is asked to provide a Dell EMC modular infrastructure that offers the most powerful and scalable computing capabilities and works with virtually any network, storage, or management infrastructure.
Which product should they choose?
A network administrator needs to size an IP subnet to address his 60,000 clients.
Which subnet will fulfill the requirement without using unnecessary IP addresses?
A server room has two power grids, A and B. PSU1 on each server is on grid A, and PSU2 is on grid B. Grid B has significantly lower load compared to grid A.
What is the most likely cause of the unbalanced power load?
An administrator has been tasked with installing a server with greater than 2TB partition.
Which boot mode would allow this?
Match the management tool to its description.
A system administrator is securing the company’s servers. They want to use a security technology that authenticates the host system hardware.
Which technology is used for this security requirement?
What is commonly by a system administrator to prevent electrostatic discharge when working inside a Dell EMC PowerEdge server?
A server administrator needs to configure a static IP for the iDRAC on their server. What is the correct sequence to accomplish this through the LCD?
An administrator needs to configure RAID 1 in System Setup. Place the sequence in the correct order.
Which RAID level is recommended for high speed data access and maximum storage capacity?
Why is Error Correcting Code (ECC) memory beneficial in Dell EMC PowerEdge servers?
Refer to the exhibit.
An administrator has a standalone M1000e chassis with only a single CMC module. The CAT6 cable is plugged into the Ethernet port closest to the DB-9 connector. The power indicator light is lit but the administrator is unable to access the CMC module.
What could be the cause of this issue?
