Weekend Special Limited Time Flat 70% Discount offer - Ends in 0d 00h 00m 00s - Coupon code: 70spcl

Cisco 640-692 CCT Routing & Switching Exam Practice Test

Page: 1 / 9
Total 92 questions

CCT Routing & Switching Questions and Answers

Question 1

Which two of the following statements are true? (Choose two)

Options:

A.

Because FTP usually requires authentication, a Cisco router must be configured with the appropriate username and password.

B.

FTP uses UDP as its transport protocol.

C.

The copy running-config ftp: command is used to copy a configuration file from an FTP server to the running configuration.

D.

A router can act as an FTP server.

E.

FTP can be used to load Cisco IOS software to router in ROMMON mode.

Question 2

Which bits represent the boot field in the configuration register value?

Options:

A.

highest two bits

B.

highest four bits

C.

lowest two bits

D.

lowest four bits

Question 3

Which of the following is a DTE device?

Options:

A.

router

B.

CSU/DSU

C.

cable modem

D.

DSL modem

Question 4

A null modem cable uses which adapter type?

Options:

A.

RJ-11

B.

RJ-45

C.

RS-323

D.

RS-232

E.

USB

Question 5

Which two of the following are installed fiber-optic connectors? (Choose two)

Options:

A.

subscriber

B.

crossover

C.

multi-dimension

D.

Lucent

Question 6

Which three of the following statements are true about a smart jack? (Choose three)

Options:

A.

It provides signal conversion.

B.

It operates at Layer 2 of the OSI model.

C.

It regenerates the signal to compensate for signal degradation from line transmission.

D.

It provides loopback testing.

E.

It acts as a concentration point for dial-in and dial-out connections.

Question 7

Which three of the following statements are true? (Choose three.)

Options:

A.

Each IP address has two parts: a network ID and a host ID

B.

An IP subnet equals a broadcast domain.

C.

An IPv4 address contains 36 bits

D.

172.16.1.18 is a Class A address

E.

A subnet address is created by borrowing bits from the original host ID

Question 8

The colored wires at one end of the cable in the reverse sequence of the colored wires at the other end of the cable. Which cable does this describe?

Options:

A.

Rolled

B.

Coaxial

C.

Crossover

D.

Straight-through

Question 9

Refer to the exhibit.

Question # 9

Of which cable type this an example?

Options:

A.

RJ-45 straight-through

B.

RJ-45

C.

RJ-45 rollover

D.

RJ-11

E.

RJ-45 crossover

Question 10

Which command initiates the copy of an IOS image to a Cisco device?

Options:

A.

copy flash tftp

B.

copy tftp flash

C.

copy tftp ftp

D.

copy tftp nvram

E.

xmodem flash

Page: 1 / 9
Total 92 questions